Technical specifications: 1. Cutting Material: 30-450g/m2 All kinds of paper. 2. Maximum width of raw material: 1600 mm. 3. Maximum cutting speed: 250m/min. (Slitting speed depends on material) 4. Rewinding maximum load: 2000kg; Rewinding maximum diameter: 1800mm. 5. Rewinding width 400-1600 mm. 6. Maximum load-bearing capacity of winding: 1000kg; Maximum diameter of winding: slitting and rewinding three pieces of 1300mm, slitting and rewinding 1000mm, slicing width 900mm. 7. Minimum slitting width: 40mm. 8. The irregularity of winding is less than (+/-0.50mm). 9. Total machine power: AC380V four-wire about 7.5KW + 7.5KW. 10 Air pressure: 7kg/cm3 11. Appearance size of the machine: 4680 mm (long)*2200 mm (wide)*1216 mm (high).
Machine self-weight: about 4 tons.
Basic functions of this machine: the whole machine is controlled by two tension sections of feeding and winding; deviation rectification and axle-less heavy feeding Arm unwinding, hydraulic lifting and pneumatic braking; Servo process correction; Horizontal unloading and manual load regulation Blade Edge Device; Drawing and Cutting Synchronization Mechanism, Bottom Roller+Air Expansion Shaft Rewinding, Pneumatic Push, Hydraulic Shovel,The blanking and winding parts are all wallboard type. PLC computer control.
1. The machine is rewinding (up to three pieces)+multi-segment strip type. 2. The main engine adopts 7.5KW+7.5KW traction frequency converter control system. 3. Rewinding is a non-axle hydraulic rewinding device, suitable for 3, 6, 12 inch tube core. 4. Rewinding constant tension control system with two multi-point pneumatic brakes. 5. Rewinding with automatic deviation correction and side tracking system, total stroke 100 mm. 6. Horizontal feeding mode, manual adjustment of lotus leaf edge device. 7. All shafts of the slitting part are driven synchronously. The slitting part is divided into upper and lower circular knife device and integral tool shifting structure (adjusting knife Convenient).
8. Arc roll unfolding device. 9. Rewinding is roll-type of rubber-steel plus air-swelling shaft surface coiling, down-drawing, 3-inch air-swelling shaft (with calibration,Inflatable gun). 10. Surface HV700 superhard wear-resistant aluminium guide roller. 11. The diameter of active roll cots is 265 mm and that of hard chromium plating is 240 mm. 12. The wall plate of the main engine is 40 thick A3 plate, and the bottom plate is composed of A3 square tube structure. 13. Pneumatic feeding and hydraulic feeding shovel. 14.Main electrical switches, low voltage electrical appliances, bearings, NSK of Japan; oil station and valve body are Taiwan.
In particular: 1. PLC, touch screen and driver are all Japanese Mitsubishi brand. 2. the low voltage electrical components is Schneider. 3. All parts are nickel-phosphorus plated. 4. Change butterfly brake to multi-point pneumatic brake. 5. Rubber arc roll is replaced by high precision steel arc roll.
Complaint
