DTH Hammer Breakout Bench Tools for Dismantling 3-24 DTH Hammers

Electric DTH Hammer breakout bench for 3.5-10 inch hammer

Specifications
1. For disassembling the dth hammer
2. Easy operation
3. Low cost
4. For 3.5" to 10" hammers
5. Semi-automatic



It's a kind of bench to disassemble the dth hammers. The hammers range can be 3" to 10" .

The operation method as below:
1). Put hammer on the bench.
2). Adjust the position of the hammer and wrench; Use wrench to block the top sub side of hammer; Let wrench and jack in the same face.
3). Fix K-shaped base with nut.
4). Fix wrench with nuts.
5). Shake handle of jack slowly till top sub away from hammer.
6). After top sub dismantled, grease the jack, release nuts, discharge the K-shaped base and turn around the hammer.
7). Adjust the position of hammer and wrench; Use wrench to block the drive chuck of hammer; Let wrench and jack in the same face.
8). Fix hammer
9). Fix K-shaped base and the wrench with nut.
10). Shake handle of jack slowly till drive chuck away from hammer.

Technical data:

Model	CX-5(manual)	CX-8(manual)	ECX3-8A(electric)	ECX3-8B(electric)	ECX3.5-10(electric)
Operate hammers	3-5"	6-8"	3"-8"	3"-8" (Atlas copco)	3.5-10" (Sandvik)
Length	920mm	1100mm	1900mm	1060	1060
Width	510mm	620mm	900mm	930	1050
Height	875mm	875mm	850mm	1050	930
Weight	200kg	230kg	450kg	800	800