Part Description | Part Number |
VOLTAGE REGULATOR | E000-23412/1P |
AVR AS440 | E000-24403/1P |
SX460-2 AVR COMPLETE | E000-24602/1P |
AV MOUNT (AS/SX/MX AVR) | 450-15971 |
MX321-2 COMPLETE | E000-23212/1P |
RECTIFIER SERVICE KIT | RSK-2001 |
RECTIFIER SERVICE KIT | RSK-6001 |
HC4/5 RECT SERVICE KIT (TEXT) | RSK-5001 |
MARKON DIODE HUB ASSY. | 240-10335 |
GREASE (400GRM TUBE) | 45-0281 |
GIEICHRICHTERMODUL | NI910058582 |
RECTIFIER ASSEMBLY KIT UC | 45-0428 |
VARISTOR (MATCHED PAIR) | NI910035009-MP |
AS480UL KIT | E000-14808/1P |
MX341UL AVR | E000-23408 |
MX342-2 AVR | E000-23422 |
COSIMAT N+ VOLTAGE REGULATOR | NI500048901 |
VARISTOR ASSY | 450-11760/1 |
VARISTOR ASSY | 073-08059 |
1K OHM POT | 071-01649 |
ROT MET.OXIDE VARIS.Z250J/S3 | 073-08063 |
BEARING RTD TYPE 5 | 070-58083 |
FUSE-6.3A V/FAST ACTI FF | 052-01032 |
ROTOR EARTHING BRUSH | T8.04.097.00 |
RECTIFIER SERVICE KIT | RSK-1101 |
PF CONTROLLER PFC3 | E000-22090 |
HC5 QUAD DROOP (3PH) | 45-0588 |
HC4 DROOP KIT | 45-0583 |
HC4/5 RECTIFIER ASSY | 450-16016 |
PMG ASSY | 45-0341A |
HC6/CG6 RECTIFIER ASSY | 450-16025 |
HC5/6/7 QUAD DROOP KIT | 45-0691 |
EBC-1 CONTROL-MODULE (UL) | E000-14831 |
HC7 BRG DE | 45-0335 |
HC7 2B BRG NDE | 45-0336 |
KIT, HTR UPGDE, F2, 3, 110V | A040G630 |
3-PH RECTIFIER ASSY | E000-22016 |
O'RING | 051-21784 |
NDE BRG CARTRIDGE PE734 | 760-10821 |
NDE BRG KIT HC4 | 45-0320 |
UC27 NDE BEARING KIT | 45-0868 |
P80 NDE BRG KIT | 45-0407 |
MANUAL VOLTAGE REGULATOR | 450-11400 |
D.E. BEARING CARTRIDGE HC7 | 760-10552 |
D.E. BEARING KIT UC22 | 45-0365 |
NDE BEARING KIT UC22 | 45-0867 |
ANTI-VIBRATION MT SX460 AVR | 450-15923 |
FR8 DE BRG CART (6232) M/C | 800-10475 |
NDE BEARING KIT P0/P1 | 45-0866 |
NDE BEARING KIT FR8 | 45-0400 |
P80 DE BRG | 45-0408 |
SX460 UL AVR KIT | E000-24608/1P |
HC6 BRG NDE | 45-0340 |
UC27 BEARING D.E. (051-01050) | 45-0367 |
UC27 DROOP KIT | 45-0092 |
Technical specification | |
Sening input | |
Voltage | Jumper selectable 100-130V ac 1 phase or 190-264V ac 1 phase |
Frenquency | 50-60Hz nominal |
Power input |
|
Voltage | 100-264V ac 1 phase |
Frequency | 50-60Hz nominal |
Output |
|
Voltage | 82V dc @200V ac |
Current | continuous 4A transient 7.5A for 10 secs |
Resistance | 15 ohms min (10 ohms min when input volts i s less than 175ac) |
Regulation | +/-1.0% |
Thermal Drift | 0.03% per deg. C change in AVR ambient |
Typical System Response | AVR response 20ms Field current to 90% 80ms Machine Volts to 97% 300ms |
External Voltage Adjustment | +/-10% with 1 k ohm 1 watt trimmer Increasing resistance lowers voltage |
Under frequency Protection | Set point 94-98% Hz |
Unit power Dissipation | 12 watts maximum |
Build Up Voltage | 4 Volts @ AVR terminals |
Analogue input | Maximum input +/-5V dc Sensitivity 1V for 5% Generator Volts(adjustable) input resistance 1k ohm |
Quadrature Droop input | 10 ohms burden Max. sensitivity: 0.07A for 5% droop 0 PF Max. input: 0.33A |
Over Excitation protection | Set point 75V dc Time delay 10-15 seconds(fixed) |
Environmental | |
Vibration | 20-100Hz 50mm/sec 100Hz-2kHz 3.3g |
Operating temperature | -40 to +70C |
Relative Humidity 0-70C | 95% |
Storage temperature | -55 to +80C |
Notes | |
1. De-rate by 12% if mounted in portrait orientation. | |
2. With 4% engine governing. | |
3. After 2 minutes. | |
4. Generator de-rate may apply. Check with factory. | |
5. Factory set, semi-sealed, jumper selectable. | |
6. Any device connected to the analogue input must be fully floating(galvanically isolated form ground), with an insulation strength of 500V ac | |
7. De-rate output current by 5% per degree C above 60C. | |
8. Non condensing |