Complaint
| ITEM | CONDITION | RATING |
6.1 Signal Output | Black Body temperature: 420K Chopping Frequency: 1HZ, 0.3~ 3.5HZ △f
| >3000mVp-p |
6.2 Noise Output | Chopping Frequency: 1HZ, 0.3~ 3.5HZ △f
| < 70mVp-p |
6.3 Balance output | Black Body temperature: 420K Chopping Frequency: 1HZ, 0.3~ 3.5HZ △f
VA = A Element sensitivity (Vp-p) VB = B Element sensitivity (Vp-p) | |VA-VB|/(VA+VB) ×100%≤10% |
6.4 Operating Voltage | Single power supply RS=47KΩ | 2~15V |
| 6.5 Source Voltage | VD=5V,RS=47KΩ | 0.4~1.0V |
| 6.6 Circuit Configuration | See Fig.3 | |
6.7 Warm-up Time | After it conneted, it with the measurement amplifier for Fig.3 description that turns on the power supply beforehand, the amplification output is time until stabilizing. | Max: 25 Sec |
| ITEM | RATING |
| 7.1 Field of View | 113 degrees from center of Element on Axis X. |
| 90 degrees from center of Element on Axis Y. | |
| See Fig 5 | |
| 7.2Response wavelength band | Filter substrate:Silicon Cut on wavelength:5.5±0.5μm Transmission:7~14μm ≥75% |
| 7.3 Transmission Characteristics of filter | See Fig 6 |
| ITEM | RATING |
| 8.1Operating Tmeperature | -30~70 ºC |
| 8.2Storage Temperatur | -40~80 ººC |
| 8.3 Relative Humidity | The sensor shall operate without increase in Noise Output when exposed to 90 to 95% RH at 30ºC continuously |
8.4 Hermetic Seal | No bubbles visible in the 125±5ºC fluorocarbon bath(FC-40) for 20sec |
| 8.5 Reliability Test | Specified in Appendix1( page13~14) |
