0.5% Accuracy Stainless Steel Material Grease Micro Oval Gear Flow Meter

Function of Circular Gear Flow Meter
1.The measuring gears are driven by the liquid flow on the principle of a gear motor.
2.The gears run without contact in the measuring chamber. The bearing elements are low-friction ball wlain bearings.
3.The movement of the gears is sampled without contact by means of two sensors
located in the cover. Between sensor compartment and rneasuring chamber is located a pressure-resistant, non-magnetic separator plate.
4.When the measuring mechanism rotates by one tooth pitch, the sensor emits a signal which corresponds to the geometrical tooth volume Vzg
5.The signal is converted into a square-wave signal by the preamplifier.
6.The two-channel sampling permits better resolution as well as recognition of the flow direction
Product Characteristics of of Circular Gear Flow Meter
1) Optimized for individual applications because the series have been rendered media-specific by means of di ffering clearances, bearing variants and materials.
2) Wide measuring ranges with sizes graduated to meet specific requirements.
3) Measurement independent of viscosity within the specified ranges.
4) Low pressure drop
5) High-response measurement
6) High working pressure
7) Low noise emission
8) High-precision measurement with outstanding reproducibility
9) Temperature-independent output signals over a wide temperature range
10) High degree of accuracy, even with low flow rates at the bottom end of the measuring range
11) High working reliability of the electronics
12) Easy to use terminal of the preamplifier
13) Working indication of the electronic
14) Sensor system and preamplifier in EMC-compatible design
15) Explosion-proof version available for all volume counters

Application of Circular Gear Flow Meter
Using condition
gear lubrication,fuel consumption monitor, robot glue dispenser, electrostatic coating equipment, hydraulic leak,diesel injection test bench, Unmanned Aerial Vehicle, two-component system, hydraulic pump tester, polyurethane foaming machine,chip cutting equipment, water treatment, twin-screw extruder, freon Measurement, hot melt dispensing, Gasoline Measurement, Odorant injection, Automotive Engineering and Design, Urethane Flow control etc.
Medium:
Grease, fuel, oil, gasoline, polyurethane,alcohol,water, glue, electrolyte,brake fluid, skydrol,gear oil,offset ink,wax,paint,polyol, isocyanate, adhesives, resin, silicon, clear lacquer, cavity waxes,solvent

B.[Parameter]

C.[ Working Condition ]

    a.Hydraulic System,Hydraulic oil

• The strict working condition,So the Heat Hydraulic Petrol Flow Meter Test Bench must with longer workinglife;
• The Hydraulic system with high pressure,Normal the pressure is more than 16Mpa;
• Test for Hydraulic oil,The medium must is pure,the micro flow mete need provide the filter;
• The Hydraulic system is more professional system,So the manufacture with professional engineers and Low cost aftersales.

   b. The common rail injector test bench

• The test bench Heat Hydraulic Petrol Flow Meter Test Bench's flow range is 0.7~400 ml/min,Our micro flowmeter is 1~800 ml/min;
• The special flow meter need higher pulse parameter,The Model M3 with 0.07 ml/pulse;
• In the test process,The Heat Hydraulic Petrol Flow Meter Test Bench need provide the filter.