| Front Angle | The range of the cutting material | Steel types | Note | | |
| 0° | 1.the profile angle is bigger and the strength is higher, so it's suitable for cutting different kinds of the material | | It's better to choose the bigger front tooth agnle when the stiffness for the procee system is poor or the power for the saw machines is shortage | | |
| 0°~5° | 1.suitable for cutting brittle materials; | Such as: gray cast iron, | | |
| 2.suitable for cutting hard material; | High speed steel and chilled cast iron, tool steel, alloy steel, spring steel, high quality carbon structural steel, bearing steel, steel, martensite stainless steel and heat resistant steel | | |
| 3.Suitable for interrupted cutting or the forging ,casting with crustaceous; | (HT200,65Mn,W18Cr4V,T12,50Cr,60Si2MnA,1Cr12,1Cr13,GCr15) | | |
| 4.applicable to small section,thin walled pipe | | | |
| 6°~10° | 1.applicable to the workpiece material strength,low hardness, and good plasticity | Such as: ordinary carbon structural steel, high quality carbon structural steel, alloy steel, carbon tool steel and austenitic stainless steel, nodular cast iron, nonferrous metals | | | |
| (Q235-A,20,30,45,T10,40Cr,20CrMo,1Cr18Ni9Ti,Cu | | |
| 2.suitable for cutting solid material,thick walled pipes | And so on) | | |
Complaint
