Complaint
Directions for using:
Into the bubble process
1. Unscrew the liquid cover on the top of the equipment, add the special combustion chamber foam cleaning liquid, and tighten the cover.
2. Remove the spark plug from each cylinder.
3. Connect with compressed air, point the transfer valve to foam, and adjust the pressure to about 3-4kg.
4. Insert the outlet tube into the combustion chamber from the spark plug, and spray the foam liquid into each cylinder.
5. Soak the foam in the cylinder for about 5-7 minutes.
(if the single soaking time is more than 15 minutes, the oil should be changed.)
Waste liquid extraction process
1. Insert the suction pipe into the bottom of the combustion chamber from the spark plug.
2, the switch valve points to the recovery, the combustion chamber carbon, impurities and old cleaning liquid all back to the waste liquid bottle.
3. Insert the air blower into the spark plug and blow-dry the combustion chamber.
(this step must not be omitted)
The final workflow
1. Open the drain ball valve to drain waste liquid.
2. Idling the engine 3 to 5 times to drain the rare cleaning fluid from the combustion chamber.
3. Carefully put back all spark plugs and ignition wires, and start the engine for 2 minutes.
Tip:
For a bottle of 4 cylinder car cleaning liquid can be carried out two times of foam cleaning process.
The effect of combustion chamber cleaning: the vehicle power is improved after cleaning, the startup is smooth, the acceleration is brisk, the fuel consumption is reduced, the tail gas emission is reduced, the performance is restored as new.
