Bitvisus HDMI 6 Outputs Display 1X6 6X1 Video Wall Controller 2X6 1X5 1X7 Video Switcher EDID HDMI Switcher

A: Industrial seat, RS232 control loop out, used in cascade mode to loop out RS232 commands to the next device.
B:Network interface, TCP network protocol, is used for the control system to issue instructions to control the device.
C:Industrial seat, used for RS232 control, used to issue RS232 commands.
D:Dip switch (Board id): indicates the ID of the current device in cascade mode. For detailed settings, see Note 1 below.
E:IR is used for receiving remote control signals,Need external IR receiver.
F, G, H,I: 4 HDMI input ports, of which I port is 4K60, F/G/H port is 4K30, suitable for graphics card output on PC host or other devices. There is an LED light next to each HDMI interface. The light indicates that the HDMI interface has a signal input.
J: 1 DP input interface, 4K60 input, suitable for graphics card output on PC host or other devices.
K: Audio output interface, used for audio output devices: earphones, etc.
L: DP ring output interface, when multiple devices are cascaded, it acts as the DP input source of another BIT_V409R device. The LED light (loop) next to the interface indicates that there is a loop-out signal output. (In single-screen mode, the loop-out follows the selection of the input source channel to switch. In non-single-screen mode, only the loop-out DP signal is supported).
M: Power switch