LED Dual-Beam Vehicle Detector/Traffic Detector/Loop Detector for Barrier Gate

1. Vehicle Detector Technical Parameter
   1)   Input Voltage: DC12V  150m
   2)   Working Frequency: 24-24.5GHz
   3)   Modulation Mode: FMCW
   4)   Sending Power: 10-15dBm
   5)   Angle between the Beam and Pole: Wide wave <15°, Narrow wave <12°
   6)   Detection Distance: 1 - 6 meters, ±0.2 meters
   7)   Communication Method: RS485, Baud Rate 115200
   8)   Working Temperature: -40ºC~+85ºC
   9)   Protection Level: IP67
  10)   Dimension(L*W*H): 131mm*106mm*28.5mm

2. Are you still troubled to install loop detector and loops?

   1) Cutting ground-Waste time and not good looking;

   2) Complex wiring-Messy and Difficult;

   3) Mud road-Cannot fix the loop;

   4) Cannot detect big truck, trailer or other vehicles with high-bed.

3. Why choose barrier radar detector?

   1) Can replace loop detector completely; no wiring layout, save time and cost.

   2) Easy installation; Easy parameters setting; Adjustable distance from 1 to 6m.

   3) Work in range of 24-24.5Ghz without effects from any climatic environment.

   4) Can effectively distinguish vehicles and humans to avoid any hitting.

   5) Can be used for trigger detection, e.g. trigger camera to capture the picture.

   6) Can be used to trigger the alarm in the warning zone.

   7) Can record the traffic and no data is lost when power is off.

4. Vehicle Detector Installation
  1) The trigger radar and the anti-smash radar should be installed perpendicular to the lane's direction. The anti-smash radar is installed on the               cabinet below the barrier pole. The trigger radar is installed on the special bracket for the radar installation. The optimal height from the ground to       the radar center is 0.6 meters.

  2) The barrier's cabinet must be fixed firmly to avoid shaking when the barrier is working.

  3) Within the detection area, there should be no obstacles other than the barrier pole, e.g. traffic cones, isolation bars, signs, etc..

  4) Please update the radar background in time after the environment in the detecting area is changed.
 

5. Wiring Definition