10km 11AC 5GHz 900Mbps Wireless Bridge, Ptp Ptmp

Min.Order: 100
Product origin: Shenzhen, Guangdong, China
Infringement complaint: complaintComplaint
US$ 1 ~ 68

Description
Detailed Photos

 


Product Description

CPE-890DH is an high power industrial 5G outdoor CPE with 10KM PTP/PTMP range. Comply with the next generation 802.11ac Wi-Fi standard, Qualcomm Chipset, combined 900Mbps high speed in 5.8G, equipped Gigabit WAN port, 3 times Ethernet data rate faster than 300Mbps model; It with LED display to show and configure CPE's operation mode, Channel, IP address and Signal Strength, simple to do the Point to Point connection by reset button, no need to access into GUI.


900Mbps Data Rate & Gigabit WAN/LAN Ports 
CPE-890DH features 802.11ac Wi-Fi and 2*2 MIMO technology, 900Mbps wireless speed. Equipped with Gigabit Ethernet port ensures high speed internet access and more end users access.


5GHz frequency, more channels, lower latency, higher stability
CPE890DH with full frequency of 5020~6100MHz, more than 200 channels available, it avoid the frequency interference problem, full meet with data transmission in fast speed, low delay, high stability requirement in wireless security or data transmission.

10KM PTP/PTMP Distance  
Designed in two line Power Amplifier on PCB board, the power can be 500mW high power, 18dBi MIMO high gain panel antenna, greatly increase the Wi-Fi range to 10KM distance, then supply the stable Wi-Fi signal for users.

LED Display
CPE-890DH with LED display to show AP/Client operation mode, Channels, IP address and RF Power; What's more, it is easy to setup CPE-890DH operation mode, IP address, Channels by set switch on product, no need to access into GUI, avoid the complex setup program, simple to check the working status.


Power over Ethernet
CPE-890DH has integrated passive Power over Ethernet (PoE) (IEEE802.3af 48V PoE is optional), for easy installation and lower cost. So it can be installed in areas where power outlets are not readily available, eliminating the mess of altering existing network infrastructure.



Main Features:
  1. Comply with IEEE 802.11ac/a/n, 5GHz,900Mbps Data Rate
  2. 1*10/100/1000Mbps WAN Port, 1*10/100/1000Mbps LAN Port
  3. 500mW high power, build in 18dBi MIMO panel antenna, stronger signal strength, more wireless coverage
  4. Support passive PoE 24V; 48V IEEE 802.3af PoE is optional 
  5. Support SSID broadcasting, Muiti SSID up to 4, then support tag VLAN based on SSID. 
  6. Support Gateway (PPPOE, static IP, dynamic IP), Wireless AP, Repeater, WISP, WDS operation mode
  7. With function of build in firewall, IP filter, URL filter and MAC filter  
  8. Comply with IEEE 802.3az standard, RF power adjustment and frequency analyzer for better application in different environment
  9. Support DDNS, VPN pass through, Port forwarding and DMZ host
  10. Support 64/128-bit WEP security, 128bit WPA (TKIP/AES) security

Product Spec.:
 
Hardware:
ChipsetQualcomm QCA9563+QCA9886+QCA8334
Standard802.11ac/a, MIMO technology
Memory128MB DDR2 RAM
Flash16MB
Interface1 * 10/100/1000Mbps RJ45 WAN Port
1 * 10/100/1000Mbps RJ45 LAN Port
1 * LED display, 1 * F(Function) switch button, 1 * S(Select) button,  press it to setup WDS PTP/PTMP connection
1 * Reset button, press 15 seconds to revert to default setting/press 1 seconds to finish the WDS PTP/PTMP connection
AntennaBuild in 18dBi MIMO Panel Antenna
Power consumption24V PoE, <15W
ESD±6KV
Surge±2KV
Water Proof LevelIP65
Size315mm * 145 mm * 80mm
RF Data


Frequency
5GHz: 802.11a/ac
5GHz: Standard: 5150~5825MHz, Debug: 5020~6100MHz
Throughput900Mbps
ModulationOFDM = BPSK,QPSK, 16-QAM, 64-QAM
DSSS = DBPSK, DQPSK, CCK
Receive Sensitivity& RF Power
RF Power802.11a54M23±2dBm6M26±2dBm
802.11n HT20MCS722±2dBmMCS025±2dBm
802.11n HT40MCS721±2dBmMCS024±2dBm
802.11ac HT80MCS920±2dBmMCS023±2dBm
Receive Sensitivity802.11a54M-72dBm6M-90dBm
802.11n HT20  MCS7-70dBmMCS0 .-88dBm
802.11n HT40MCS7-68dBmMCS0 .-86dBm
802.11ac HT80MCS9-58dBmMCS0 .-85dBm
EVM802.11a: ≤-25 dB; 802.11n: ≤-28 dB; 802.11ac: ≤-32 dB
Firmware Features:
Operation modeWireless AP, Client
Wireless Security 64/128-bit WEP, WPA / WPA2, WPA-PSK/ WPA2-PSK encryption
SSIDMultiple SSID up to 4
FirewallDoS, SPI Firewall, IP Address Filter/MAC Address Filter/Domain Filter
IP and MAC Address Binding
ProtocolsIPv4
Others:
Package Contents900Mbps Dual Band wireless access point
Ethernet Cable     
24V PoE adapter                                     
Quick Installation Guide
Setting Accessory
System RequirementsMicrosoft Windows 98SE, NT, 2000, XP, Vista™ or Windows 7, Windows 8, MAC OS, NetWare, UNIX or Linux
EnvironmentOperating Temperature: -30~55 ºC
Storage Temperature: -40~70 ºC
Humidity: 5%~95% non-condensing
ManagementFirmware GUI ,Remote Management, WLAN Controller, Cloud Management System
Scroll to Top