| Model | CA20 amplifier |
| Channel number | 2 |
| Rated output power | Stereo power 8Ω | 1350W |
| Stereo power 4Ω | 2700W |
| Rated bridged output power 8Ω | 3900W |
| Output circuit type | Class H |
| Power supply | AC 160-242V 50Hz/60Hz |
| Total harmony distoration(THD) | <0.1% (1dB,20Hz-20kHz when less rated power) |
| Frequency response | 20Hz-20KHz,+0/-1dB |
| Signal to noise | >100dB |
| Slew rate | >10V/us |
| Damping factor(5Hz-1kHz) | >200 |
| IMD | <0.05% |
| Input sensitivity | +24dB (16V/rms) |
| Input impedance | 10K/20K ohms ,balance or unbalance |
| Crosstalk | >80dB |
| Input link | One balance XLR interface per channel |
| Output link | One 4-POLESpeakon interface per channel and a pair of plum blossom anti-touch binding posts |
| Protection | Full-featured protection circuit, including temperature (overheating), short circuit, DC, voltage limit, overload, overcurrent, distortion limiter, undervoltage/overvoltage, on/off noise, load mismatch (low resistance), soft-start on boot, Power-on anti-surge, radio interference, secondary wave, high-frequency output automatic detection (UHF) protection and other protections |
| LED indicator | Protection (PEA), Signal (SIG), Overheating (TEM), Bridge (BRI), Stereo (STE), Mono (PAR) |
| Cooling system | By the air convection mechanism from the front to the rear, the internal air is forced to dissipate heat, and the automatic continuously variable speed dual fans are forced to cool |
| Output circuit type | Class H |
| Height | 3U |
| Net Weight | 35.5Kg |
| Gross Weight | 37.5Kg |
| Dimensions(L*D*H) | 483*460*132mm |
| Remark:Above standard parameters are just for your reference,we can design by your requirements. |
Complaint
