Dyed Wood Veneer Plane European Lacewood Veneer Sheets

Storage
Both natural dyed veneer and reconstituted veneer are made of wood and its moisture content may therefore be subject to variation depending on the storage and work environment. It is therefore advisable to maintain humidity in the range between 40% and 70% (RH) and a reference ambient temperature of 20°C.

Warnings
Avoid-even temporarily-any contact with water and other liquids. Avoid any moisture condensation on product surface. The product must be stored on a flat surface at least 200 mm above the ground. Our wood veneer must be protected from direct and indirect light.

Application
Veneerhub natural dyed veneer and engineered veneer can be glued on all wood supports using urea or hot melt glues. Different kinds of support must be tested and assessed on a case-by- case basis.

Sanding
After the veneering process, our wood veneer must be sanded in order to prepare and clean the surface for the varnish application. This process must be carried out with 120-150- 180 grit sandpaper in a single step or in sequence using manual or automatic sanding machines. The use of 100 grit or 220/240 grit sandpaper is advised only for special decorative effects.

Polishing
Like all other types of wood, the varnishing process must be performed with a suitable product capable of protecting and preserving the wood as much as possible from chemical and physical deterioration (photo-degradation, thermal decay, etc.) as well as from mechanical degrada tion scratches, dents, etc.). The best results are achieved by selecting, among the various classes of products, those with the following characteristics: High wetting power-High yellowing retardation power-High UV protection. As for water paints, it is advisable to use products that are stable at a moderately acid pH(4-6), such as specific products for acid hardwoods.