Complaint
https://bodavalve.en.made-in-china.com
Pneumatic actuators are actuators that use pneumatic pressure to drive the opening and closing or regulating valves, also known as pneumatic actuators or pneumatic devices, but commonly referred to as pneumatic heads. Pneumatic actuators are sometimes equipped with certain auxiliary devices.
| name | description |
| material quality | carbon steel , stainless steel |
| pressure | 0.1mpa~0.8mpa |
| length | 40~450mm |
| temperature | -29°C ~60°C |
| cylinder diameter | 30mm |
| Connection method | thread |
1. Pneumatic actuators can be directly installed and connected to valves, or can be installed and connected through brackets and joints. The connecting fasteners must not be loose.
2. Ensure the coaxiality of the actuator output shaft and valve stem installation, and rotate flexibly without any crawling phenomenon.
3. The connecting pipes, joints, accessories, etc. should be clean and clean.
4. The exhaust port of the solenoid valve is always downward. When it is upward or horizontal, a bend should be connected to make the exhaust port downward.
5. Before debugging, it should be confirmed that the air pipeline is unobstructed and that the air pressure, voltage, signal, etc. meet the requirements.
6. Compressed air should be filtered, dried, and dehumidified below a dew point of -15 ° C.
7. During debugging, the solenoid valve should be turned to the automatic position.
Relieve your concerns
