PRODUCT DESCRIPTION
V200 GNSS RTK Receiver brings superior performance and high efficiency to support your fieldwork with reliable solutions. Its deployment of the advanced RTK engine and new-generation IMU guarantees a 25% performance improvement even in the most demanding environments. Thus you can count on Hi-Target V200 for better productivity
CORE TECHNOLOGY
Multi-Constellation Tracking *800 tracking channels *NGS approved full-wave GNSS antenna *Support GPS, GLONASS, GALILEO, BDS, SBAS *Supports a wide range of satellite signals *A large receiving area designed for multipath mitigation *Air dielectric is light and stable Rugged Design *IP67 dustproof and waterproof | Smart Application *Offers tilt survey with a maximum tilt angle of 30 degrees *Supports electronic bubbles *Intelligent voice assistance guides field operations. Voice can be DIY *Standard Rinex data and HI-TARGET raw data recorded simultaneously. Multi-network Connection *Supports GPRS, GSM and WCDMA *Supports WIFI |
PRODUCT SHOW
PRODUT SPECIFICATION
Satellites Signals Tracked Simultaneously | |
Channel | 800+ |
GPS | Simultaneous L1C/A, L2C,L2E, L5 |
Glonass | Simultaneous L1C/A,L1P,L2C/A(Glonass M only), L2p |
SBAS | Simultaneous L1C/A, L5 |
Galileo | Simultaneous L1,BOC,E5A,E5B, E5AltBOC1 |
BDS | B1, B2 |
QZSS | L1C/A, L1SAIF, L2C, L5 |
Static and Fast static Gnss Surveying | |
Horizontal | 2.5mm+0.5ppm RMS |
Vertical | 5mm+0.5ppm RMS |
Post Processing Kinematic Gnss Surveying | |
Horizontal | 1cm+1ppm RMS |
Vertical | 2.5cm+1ppm RMS |
initialization time | Typically 10 minutes for base while 5 minutes for rover |
initialization reliablity | Typically>99.9% |
Real time Kinematic (PPK/Stop & Go)GNSS Surveying | |
Single Baseline | |
Horizontal | 8mm+1ppm RMS |
Vertical | 15mm+1ppm RMS |
Network RTK | |
Horizontal | 8mm+0.5ppm RMS |
Vertical | 15mm+0.5ppm RMS |
initialization time | Typically<8 seconds |
initialization reliablity | Typically>99.9% |
Code differential Gnss postioning | |
Horizontal | 25cm+1ppm RMS |
Vertical | 50cm+1ppm RMS |
SBAS3 | 0.50m Horizontal, 0.85m Vertical |
Network Communication | |
Full integrated, fully sealed internal WCDMA, compatible with GPRS, GSM WIFI frequency is 2.4G, supports the standard protocol 802.11b/g/n Network RTK(via CORS) range 20-50km | |
Hi-Target internal UHF Radio(Standard) | |
Frequency | 410-470MHz with 116 channels |
transmitting power | 1w,2w,5w adjustable |
transmitting speed | 9.6kbps, 19.2kbps |
working range | 5km typical, 8-10km optional |
Pacific Crest XDL Micro internal UHF Radio | |
Frequency | 403-473MHz |
transmitting power | w,2w,5w adjustable |
transmitting speed | 9.6kbps, 19.2kbps |
Support most of radio communication protocol | |
working range | 3-5km typical, 15-20km optional |
Hi-Target external UHF Radio(Standdard) | |
Frequency | 460MHz with 116 channels |
transmitting power | 5w,10w,20w,30w adjustable |
transmitting speed | up to 19.2kbps |
working range | 8-10km typical, 15-20km optional |
Pacific Crest ADL Vantage Pro internal UHF Radio | |
Frequency | 390-430MHz or 430-470MHz |
transmitting power | 4w-35w adjustable |
transmitting speed | up to 19.2kbps |
Support most of radio communication protocol | |
working range | 8-10km typical, 15-20km optional |
Physical | |
Dimensions(W*H) | 153mm*83mm(6.02 inch*3.27 inch) |
Weight | 950g(2.09Lb) without internal battery |
Operating temperature | -40ºC~+65ºC(-40ºF~149ºF) |
Storage temperature | -55ºC~+85ºC(-67ºF~185ºF) |
Humidity | 100%, considering |
Water/ Dustproof | IP67 dustpoorf,protected from temporary immersion to depth of 1m(3.28ft) |
Shock & Vibration | designed to survive a 3m (9.84ft) natural fall onto concrete |
Electrical | |
Power 6V to 28V DC external power input | |
power consumption≤3.5W | |
Automatic switching between internal power and external power rechargeable, removable 7.4V, 5000mAh lithium-ion battery in internal battery compartment | |
Internal Battery Life | |
Static more than 10 hours | |
RTK rover(UHF/ GPRS/3G) 6-10 hours | |
RTK base more than 6 hours | |
I/O interface | |
Bluetooth,NFC | ×1 |
Standard USB2.0 port | ×1 |
TNC antenna connector | ×1 |
RS232 serial port | ×1 |
DC Power input (5-pin) | ×1 |
MicroSD card port | ×1 |
Tilt Survey System | |
Electronic Bubbles | |
System Configuration | |
Data Storage | |
Data Formats | |
(1Hz positioning output, up to 50hz- depends on installed option) CMR: sCMRx, CMR, CMR+input and output. RTCM: RTCM2.1, 2.2, 2.3, 3.0, 3.1, 3.2 input and output. Navigation outputs ASCII: NMEA-0183 GSV, AVR,RMC, HDT, VGK, VHD, ROT, GGK, GGA, GSA, ZDA, VTG, GST, PJT, PJK, BPQ, GLL, GRS, GBS Navigation outputs binary: GSOF |
PACKING & SHIPPING
PAYMENT
COMPANY INFORMETION
Shanghai Hexin Survey Instrument Co., LTD has 8 years' experience in geodetic surveying and cadastration surveying, we are a professional and leading enterprise in the surveying industry in MainlandChina. We specialize in the R&D and manufacturing and sales of all kinds of surveying products, including total station, electronic theodolite, electronic distance meter, automatic level, laser level, reflector prism, surveying accessory, GPS receiver, mapping software, etc.The marketing model advocated by us is not a simple sense of "selling products", instead, pre-sales service, services during operation and after-sales service are integrated in entire operating activities. It makes the customers feel that they purchased not only a commodity, but also a professional service.We welcome new and old customers from all walks of life to contact us for future business relationships and achieving mutual success!
FAQ
Q:How to turn off voice broadcast of receiver?
A: a. Enter the WEBUI, find the voice switch in the settings page and turn it off.
b. Controller Software→Device→Device Setting, turn off the "enable voice", and click"ok"
Q: Can the base station and rover station be interchangeable?
A: The difference between the rover station and the base station is that the accessories are different, the function and hardware configuration are the same.You can use the controller to choose the working mode of the device and set it as the base station or rover station.
Q: What is CORS?
A: CORS is called a continuous operating reference station system. It can be understood as a bas e station that is erected at a fixed known point and works continuously for 24 hours and sends its own data to a specific serverthrough the network. The use of CORS operation eliminates the need for a base station, and CORS is equivalent to a base station in a normal network operation.