Complaint
Product name | Taper lock bushing | ||
Material | Steel, Cast iron, Stainless steel | ||
Color | Black, Natural | ||
Application | Accopanying sprocket, V-type pulley, Timing pulley, Gear ect | ||
Inspection | 100% | ||
>> INSTALL
1) Clean shaft, bore and outside of bush, and bore of hub. Remove any oil, laquer of dirt. Place bush in hub and match half holes to make comelete holes(each comeplete hole will be threaded on one side only).
2) Lightly oil thread and point of set screws, or thread and under head of cap screws. Place screws loosely in holes that are threaded on hub side.
3) Make sure bush is free in hub. Slip assembly onto shaft and locate in the desired position.
4) Tighten screws alternately and evenly until all are pulled up tightly(See table for torque settings)).
5) Hammer agsinst large end of bush using hammer and block or sleeve to avoid damage. Screws can now be turned a little more to the specified torque setting. Repeat this alternate hammering and screw re-tightening until the specified torque is reached. Fill all holes with grease to exclude dirt.
>>REMOVE
1) Remove all screws. Lightly oil thread and point of set screws, or thread and under head of cap screws.
2) Insert screws into removel holes that are threaded on the bush side. In sizes where washers are found under screws heads, be sure to use these washers.
3) Tighten screws alternately until bush is loosened in hub and then remove the coplete assembly. If bush does not loosen immediately tap on hub.
6.Our services: | 1).Competitive price | |||
2).High quality products | ||||
3).OEM service or can customized according to your drawings | ||||
4).Reply your inquiry in 24 hours | ||||
5).Professional technical team 24 hours online service | ||||
6).Provide sample service | ||||
