Complaint
It can mill almost all materials, like zirconia,PMMA,wax,hybrid materials,feldspar-type ceramics, lithium based ceramics etc.
You can use it to mill full crown,inner crown,bridge, veneer,inlay/onlay, upper implant restoration, and surgical guides, etc.
Since this milling machine has two modes-wet milling and dry milling, it is suitable for both dental clinic and dental lab use.
Product Advantage:
The spindle is very strong, with the speed up to 60,000 rpm.
The machine weight is 95kgs, heavy enough to reduce vibration during milling, which can make the machine service life longer.
Wet and dry milling mode, can mill almost all materials except the metal ones.
3 μm repeatability.
High precision.
Large angle cutting.
FAQ
1. Does the equipment need an air compressor?
The minimum requirement of air pressure is 0.45Mpa.
2. What is the thinnest cutting thickness?
Composite materials can be ground down to 0.3mm ultra-thin veneer.
3. What type of bur?
Three models in one box, .5mm, 1.0mm. 2mm.
4. What is the longest cutting unit length?
3-4 Unit Temporary Crown.
5. What are the data transmission methods?
Wired, wireless. U disk 3 kinds of transmission.
Product Parameters:
Dimensions | 415*588*578mm |
Weight | 95Kg |
Diameter of the bur head | 0.3mm,0.6mm ,1.0mm, 2.0mm |
Power | 220V/50/60HZ |
Rotation angle | A:360° ,B:25° |
Air pressure | 4.5-6.0Bar(Oil-free & water-free) |
Spindle speed | 15,000-60,000 rpm |
Materials | Zirconia,PMMA,Wax,Hybrid materials,Feldspar-type ceramics Lithium. based ceramics etc. |
Indications | Full crown. Inner crown, Bridge, veneer, Inlay/Onlay, upper implant restoration. Surgical guides |
