Description
E-100 Waterproof electrical cable wiring junction box E-100 series end seal kit can be easily discharged. The two types of end seal kits can be used with all heat tracing cables. They can be used at hazardous locations. E-100-L-E has green LED of very long life span, which can be seen from any direction. Those durable industrial grade electric devices have excellent sealing performances. They can reliably prevent moisture. They can be purchased separately. Model | E-100-E | E-100-L-E |
Components | 1pc. Of end seal kit
1pc. Of cable strap
1pc. Of lubricant | 1pc. Of end seal kit with LED
1pc. Of cable strap
1pc. Of lubricant
2pcs. Of crimp tubes
2pcs. Of PHC crimp tubes |
Service location | Hazardous or ordinary (indoor and outdoor) |
Max.Operating voltage | 254V |
Ambient temperature range | -50ºC~+40ºC |
Min.Installation temperature | -50ºC |
Total height | Approx.171mm | Approx.197mm |
Protection level | IP65 |
Outer diameter | Approx. 46mm. Can be used with 100mm insulating material | Approx. 66mm |
Impact resistance | EN50 014, ≥7j |
UV protection stability | No degradation after 1000 hours service
|
Tension elimination | >250N |
Parameter for light source of E-100-L-E
Type | |
Rated voltage range | |
Power consumption | |
Electromagnetic immunity/radiation | Confirm to EN 50 082-2:1995 EN 50081-1:1991 |
Shock resistance | Confirm to IEC 60068-2-6, 10-150HZ, 20m/s2 |
Impact resistance | Confirm to IEC 60068-2-6, 50g, 11ms |
Steel wire pliers, screw driver, special bade.
Accessories required:
Gasket
Adhesive tape
GT-66 for installation temperature higher than 4ºC. GT66
GT-54 for installation temperature higher than -40ºC. GT54
Note:
1. This component is an electric device. It should be properly installed. Measures should be taken for fire protection.
2. Leakage protection device shall be installed to prevent fire as may happen due to damage or improper installation of heat tracing cables.
3. Only those parts and components approved according to our criteria can be used. Please don't use substitutes or PVC insulation tapes.
4. As the black conductive plastics is a conductor, it should strictly insulated and kept dry. Short circuit should be prevented.
5. In peeling the insulation layer or conductive plastics, please keep the bus wire intact as any damage of bus wire may lead to overheating or short circuit.
6. To prevent short circuit, bus wire shall never be contact with each other.
Complaint
