Milling Machine Cutter Feeder Electronic Automatic Feed Turret Milling Machine Accessories

Min.Order: 1

Product origin: Zhongshan, Guangdong, China

Infringement complaint:

Complaint

US$ 135 ~ 160

Description

Automatic electrical power feed( APF500,APF750,KE400,KE500)
With 24 years manufacture experience of power table feed
SPECIFICATIONS

Milling machine cutter feeder electronic automatic feed Turret milling machine accessories
Model	POWER	MAX TORQUE		RPM
Model	POWER	lb-in	kg-cm	RPM
APF500	110V50/60HZ	135	155	0~210
APF750	110V50/60HZ	152	175	0~210
KE400	110V60HZ	550		0~200
KE500	110V60HZ	550		0~200

Caution before installation
1.Please be sure the power is off before installation,Even the power table feed not connected to the power.To avoid the accident caused during installation.
2.This power table feed has AC110V50/60HZ.Please be sure the input power is compliance with the power table feed .If the input power at user's place ia not AC110V50/60HZ,please prepare the transformer(To avoid burn down to the wires& circuit board caused by the wrong power supply).
3.Except the consumable parts or maintenance parts, do not disassembly the power table feed.To avoid any injury to operator and damage to machine caused by the wrong assembly, omission,wrong connection and short circuit.

Maintenance
1.Maintenance for gear lubrication
In every 6 months, open the gear cover,and check if lubrication for spiral gear is sufficient .It is suggested to take graphite type lubrication ,do not use silicon type lubrication.
2.Check for gear wear out
To check the gear shape of spiral gear (made of plastic 107T)is wore out .If gear wore out badly,please replace a new gear .The procedure to replace the gear at follows:
A. Open the gear cover (press the edge of hooks on both sides,and pull down).
B. Loosen C type ring,sequentially take out washer/Pouple disk set (Occlusion soft set/ Pouple disk) /Pin /abrasive washer /gear york set(spiral gear /york set) /thrust bearing.
C.Disassembly gear york set ,replace spiral gear ,then install it back by sequentially.Occlusion soft set and surface of York set must be kept clean,can not attached with oil.If there are any oil ,please clean it by volatile solvent ,do not clean by water .
3.Checking for carbon brush wear out
In every 6 months, open carbon brush cap ,to check brush is wore out.If the length of brush is less than 5mm, the brush must be replaced immediately(2sets at the front &back ).
FAQ
Q:How long is the warranty period ?
A: One year.

Q: How long is the delivery time?
A: Generally it takes 3-7 days if the products are in stock. If the products are not in stock, it will take 8-20 days.

Q: Does your product have a factory inspection before shipment?
A: 100% self-inspection before shipment.

Q: Can you provide some free samples?
A: Actually we provide a very competitive price, when you place the bulk order then the cost of sample will be refound to you.

Q: What kind of packing do you send?
A: We use high quality cartons, internal environmental protection buffer material.

Q: What is our loading port?
A: Usually in Xiamen port, or as you required.

Q: Is it possible to know how are my products going on without visiting your company?
A: We will offer a detailed production schedule and send weekly reports with pictures or videos which show the machining progress.

Q: Can we get some samples before mass production?
A: Yes ,kindly send us an email and our sales maneger will arrange the samples as you required .

Q: How long can I get the sample?
A: Within 3 - 7 days is required generally.

Forward

Related products