Introduction: IEC61032 IEC60529 IEC60335 (Test probe B) is the necessary implement in protection against electric shock test for household and other have similar matter electrical appliances.
This is the "International" test finger required by most IEC61032 test probe B, EN and CSA Standards, in addition to many UL Standards. Built in strict accordance to the newest requirements with integral palm simulator. The handle and stop face are made of nylon. Finger is made of stainless steel. All parts precision machined.
The Standard Test Finger Probe / The Standard Test Knurled Finger Probe / Test Probe B / IP2X Protection Grade Probe.
Note:The Test Probe is made of precision stainless steel products, take and put down slightly when using, and pay attention to maintenance.
Application: 1. The joint part of The Standard Test Knurled Finger Probe can't touch the live parts or close to the dangerous parts, and 50 mm to 20 mm baffle plate cannot enter. 2. In the prevent electric shock test, wires , power devices, and lighting devices are needed. 3. Both joints shall permit movement in the same plane and the same direction through an angle of 90° with a 0° to +10° tolerance This probe is intended to verify the basic protection against access to hazardous parts. It is also used to verify the protection against access with a finger. Tolerance on dimensions when no specific tolerance is given: - on angles: 0−10° - on linear dimensions: up to 25 mm: 0 − 0,05 mm; over 25 mm: ± 0,2 mm.
Complaint
