Complaint
I.Overview
The aviation fuel water reaction automatic tester meets the requirements of GB/T 1793 and ASTMD 1094 test methods, and is suitable for the determination of water-soluble components in aviation gasoline and aviation turbine fuel, as well as the influence of these components on volume change and oil-water interface.II.Main features.
II.Functional features
1. Pneumatic drive to achieve vertical reciprocating motion
2. Microcomputer control, accurate control of test time, test stroke, calculation of round-trip time
3. Provide flexible adjustment of various experimental methods, itinerary, time and other parameters
4. Automatically store data, connect the serial port to the host computer, print data, and upload data
5. Equipped with LED light source.
III.Technical parameters
1. Power supply: AC 220 V ± 0.150 Hz
2. Power: 40W
3. Communication port: 232 serial port
4. Printer: Thermal Micro Printer
5. Light source: LED light
6. Amplitude adjustment: 120~250mm (adjustable every 5mm)
7. Speed adjustment: 2 * 4 times/second
8. Timing: 115 x 125 seconds
9. Standing time: 5 minutes
10. Environmental requirements: temperature 5≤40ºC, humidity≤0.85
11. Dimensions and weight: 480 × 430 × 620 (mm); 42 kg
IV.Daily maintenance
1. The guide rail and the slider need to be dripped with an appropriate amount of general-purpose lubricating oil (5~8 drops, do not drip too much, so as to avoid splashing during operation) in 500 tests or 2 months interval.
2. For the cylinder and the reversing valve, please drop 8~12 drops of general-purpose lubricating oil into the air inlet on the back of the instrument at intervals of about every 6 months. The lubricating oil will turn into oil mist with the air flow. Lubricate.
3. For the muffler pads on the upper and lower sides of the slider, due to the influence of the frequency of use, stroke and temperature, the time for the cushion to collapse and fail is quite different. Please pay attention to observe the cushion on the upper end of the slider. If it is damaged, please replace it in time. The replacement method is to twist off the four fastening nuts, remove the four clamping pieces, and remove the failed cushion. The new cushion is opened on the side and inserted into the guide rail.
4. Note that the installed new cushion should not be in contact with the guide rail, and ensure that there is a gap in the center of the guide rail, so as to prevent the rubber from sticking to the guide rail during movement, which is difficult to clean and easily damages the slider.
5. The new cushion should be installed in the side opening, and the clamping piece can press the opening to ensure the service life of the cushion.
| HuaZheng Electric Manufacturing (Baoding) Co.,Ltd is the supplier of the State Grid in China.It means we are the supplier of the Chinese Government.And our products spread throughout the whole China. What's more, our customers come from different countries like America, England, Bulgaria, Brazil, Chile, Malysia, Vietnam and so on. Our main products are Insulation Oil Tester, Cable Fault Locator, Power Quality Analyzer, High Voltage Generator, High Voltage Capacitor, Testing Transformer and so on. |
